You are viewing an Archived item in your Knowledge Base, it is not publicly accessible.

  • Home
  • Hardware & Software
  • Snom

SNOM: Multicast Paging Setup

Written by Marissa Orsini

Updated at December 3rd, 2024

Contact Us

  • The Essentials
    FAQs Forms
  • Announcements
    Carrier Events mFax Events Platform Events Release Notes
  • Billing Administration
    Datagate OneBill
  • Faxing
    mFax - Analog mFax - Digital Native Fax
  • Hardware & Software
    Manual Configuration Provisioning NDP Axis Cisco Fanvil Grandstream Polycom Snom Yealink Mobile Applications Desktop Applications Mobile-X SNAPbuilder TeamMate Connector UC Integrator
  • Hosted Voice
    Auto Attendants Branding Call Queues Call Routing CDRs Conferencing E-911 Features Fraud Integrations Inventory / Phone Numbers Local & Toll Free Porting Onboarding Recommendations SNAP.HD SIP Trunking SMS / MMS Users Voicemail Caller ID
  • Troubleshooting
    VoIPmonitor Firewalls PBX
  • Ray's Stuff
+ More

Table of Contents

Configure Paging Sender via Override Configure Paging Sender via Web GUI

Scope:

The following steps will allow you to set up Multicast Paging on both the sender and receiver on Snom D785 phones. This will enable to you speak to receivers.

 

Requirements:

  • Access to the Snom D785 Phone's UI
  • Access to the Manager Portal 
 

 

Configure Paging Sender via Override

  1. Log onto the Manager Portal
  2. Go to Inventory > Phone Hardware
  3. Click Edit for the device you would like to setup
  4. Go to Advanced > Overrides and enter the following:
    NOTE: These overrides are for soft key context 3 and will replace the help button on the LCD screen
multicast_listen="on"
mc_address1="224.0.1.116:5001,volmax=1,name=main"
context_key3="keyevent F_ZONES"
  1. Click Save and Resync


Configure Paging Sender via Web GUI

  1. Obtain the IP address of the phone and log onto the Web GUI
  2. Go to Function Keys > Context-Sensitive Keys
  3. Select Type as Key Event, Number as Multicast Zones
  4. Click Apply at the bottom of the page and click Save Changes located at the top of the page

 

multicast snom

Was this article helpful?

Yes
No
Give feedback about this article

Related Articles

  • Add Provisioning Profile to SRAPS
  • Add Device to SRAPS

Knowledge Base Software powered by Helpjuice

Expand